A small general cargo vessel was sailing in coastal waters at about 13 knots in a moderate 1 metre swell. Two crew were tasked with cleaning work on the foredeck; they dressed and assembled the required hose and equipment before starting forward across the hatches.
In rough weather, a safety line was usually used to secure persons walking on deck, but in this case, it was judged unnecessary as the vessel was not rolling excessively and there was no water being taken on deck.
Image Credits: nautinst.org
At one point, the OOW heard a shout and immediately saw the two crew in the water on the port side, now just aft of the bridge and about 2 metres from the ship’s side. The OOW instructed the additional crew on the bridge to use the binoculars and not to lose sight of the two men in the water. He threw a lifebelt and a smoke marker into the water, then went inside to mark the man overboard (MOB) location on the electronic chart. He then notified the Master before using the autopilot to slowly put the ship into a starboard turn (now almost two minutes after the MOB incident). He then contacted the coast radio station requesting SAR resources. By now, those on the bridge had lost sight of the victims.
Once on the bridge, the Master took over control of the ship and accelerated the starboard turn. He also activated the general alarm to alert the rest of the crew. The vessel made it back to the initial MOB position about 11.5 minutes after the two men had fallen in the water. There was no sign of the victims so another smoke marker was deployed to refresh the previous one. A SAR helicopter arrived on the scene about 40 minutes after the men had fallen into the water and immediately started searching in the vicinity of the floating lifebelt that had been earlier thrown by the OOW. Searches continued with boats and helicopter until darkness but the missing crew members were not found.
Lessons learned
If someone has fallen in the water there are many tasks to be done almost simultaneously. Only repeated practice and, especially, unannounced MOB drills can hone the crew to perform optimally.
If in doubt, always opt for more safety rather than less. In this case, the safety line was not used because it was thought unnecessary. Two men paid with their lives.
Image Credits: nautinst.org
One of the principal tasks for a MOB incident is getting the ship turned around and back to the incident area in the shortest possible time. If sea room allows, hard helm should immediately be applied (to the side of the fall) and one of several well known turning methods used, as below.
Editor’s note: The Williamson turn is especially useful in reduced visibility as it brings the vessel back on a reciprocal course and into its own wake. However, with good visibility the Anderson turn should be employed as it is a quicker turn.
Reference: nautinst.org
Comments
Post a Comment